Descripción
Cisco WRV2 Wireless-G VPN Router: RangeBooster
Downloads
Cisco WRV2 Wireless-G VPN Router: RangeBooster
Secure Wireless Network Access for Small Offices
Highlights
• IPsec VPN connectivity for highly secure remote access
• Built-in 4-port /0 Fast Ethernet switch
• Multiple SSIDs and VLANs provide separate, secure networks
• Simple, browser-based configuration
Figure 1. Cisco WRV2 Wireless-G VPN Router: RangeBooster
Product Overview
The Cisco® WRV2 Wireless-G VPN Router (Figure 1) is a VPN router with an integrated wireless access point for small offices and home offices. The /0 Ethernet WAN interface connects directly to your broadband DSL or cable modem. The LAN interface consists of a built-in 4-port, full-duplex /0 Ethernet switch that can connect up to four devices. The wireless access point supports 802.11b/g and incorporates RangeBooster technology, which utilizes multiple-input, multiple-output (MIMO) antennas to provide increased coverage and reliability.
The Cisco WRV2 has the advanced security functions needed for business networking, including a stateful packet inspection (SPI) firewall with denial-of-service (DoS) prevention, as well as a VPN engine for highly secure communication between mobile or remote workers and branch offices. It offers support for multiple service set identifiers (SSIDs) and VLANs for traffic separation. The WRV2 implements Wi-Fi Protected Access Pre-Shared Key (WPA2-PSK), WPA2 Enterprise, and Wired Equivalent Privacy (WEP) encryption, along with other security features, including MAC-based filtering and the ability to enable and disable SSID broadcasts.
Wireless networking in business environments requires flexibility. The Cisco WRV2 can expand or reduce the area of your wireless network via a wireless distribution system (WDS), which allows you to expand your network by connecting select Cisco standalone access points, without the need for additional wiring. This capability, along with the ability to increase or decrease the RF output power, allows for optimal wireless coverage.
The WRV2's support for wireless QoS (Wi-Fi Multimedia [WMM]) and wired QoS (port prioritization) helps maintain consistent voice and video quality throughout your network.
Features
• 802.11g supports data rates up to 54 Mbps
• Dual fixed antennas with MIMO provide up to three times better coverage than standard 802.11g
• Supports multiple SSID mapping to specific VLANs to create separate, secured networks
• Supports IP Security (IPsec) VPN tunnels with QuickVPN support
• Dual Point-to-Point Protocol over Ethernet (PPPoE) profiles allow easy switching between PPPoE accounts
• Supports Telstra BigPond Heartbeat
• Supports multiple languages on web administrator interface and setup wizard
• Wireless SSIDs can be enabled/disabled based on a predefined schedule
• Supports Trivial File Transfer Protocol (TFTP) based firmware upgrade in addition to web-based firmware upgrade
Specifications
Table 1 contains the specifications, package contents, and minimum requirements for the Cisco WRV2 Wireless-G VPN Router.
Table 1. Specifications for the Cisco WRV2 Wireless-G VPN Router: RangeBooster
Specifications
Standards
IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.1X (security authentication), IEEE 802.11i (security WPA2), IEEE 802.11e (wireless QoS)
Ports
1 power port (12V/1A), four /0 RJ-45 ports, one /0 RJ-45 Internet port
Buttons
Reset
Cabling type
Unshielded twisted pair (UTP) Category 5
LEDs
Power, DMZ, Wireless, Internet, LAN 1 through 4
Operating system
Linux
Performance
NAT throughput
3 Mbps
IPsec throughput
23 Mbps
Setup/Configuration
User interface
Built-in web user interface for easy browser-based configuration (HTTP/HTTPS)
Management
SNMP version
SNMP versions 1 and 2c
Event logging
Local, syslog, email
Firmware upgrade
Firmware upgradable through web-browser and TFTP utility
Diagnostics
Flash, RAM, LAN, WLAN
Wireless
Modulation
Radio and modulation type: 802.11b/direct-sequence spread spectrum (DSSS), 802.11g/orthogonal frequency-division multiplexing (OFDM)
Data rates supported
802.11b: 1, 2, 5.5, 11 Mbps, 802.11g: 6, , 11, 12, 18, 24, 36, 48, 54 Mbps
Operating channels
11 North America, most of Europe (ETSI and Japan)
Number of external antennas
2 (omnidirectional)
Antenna connector type
Fixed
Transmit power
Transmit power (adjustable) at normal temp range: 802.11.g: 18dBm (typical).
802.11.b: 20 dBm (typical)
Adjustable power
Yes
Antenna gain
2 dBi
Receiver sensitivity
802.11.g: 54 Mbps at -6 dBm (typical), 802.11.b: 11 Mbps at -82 dBm (typical)
Wireless QoS
WMM, 802.11e ready
Active WLAN clients
32
Security
WEP/WPA/WPA2
WEP 64 bit/128 bit, WPA Temporal Key Integrity Protocol (WPA-TKIP)/Advanced Encryption Standard (AES), WPA2-PSK, WPA2 Enterprise
802.1X RADIUS authentication
802.1X RADIUS (MD5, SHA1, Transport Layer Security [TLS], Tunneled TLS [TTLS], Protected Extensible Authentication Protocol [PEAP]), dynamically varying encryption keys
Access control
Access control list (ACL) capability: MAC based and IP based
Firewall
SPI firewall
DoS prevention
DoS prevention
Secure management
HTTPS, username/password
Network
VLAN support
LAN ports and SSIDs can be mapped to up to 5 VLANs
SSID broadcast
SSID broadcast enable/disable
Multiple SSID
Supports multiple SSIDs (4), which can operate on predefined schedules
Wireless VLAN map
Supports SSID to VLAN mapping with wireless client isolation
WDS
Allows wireless signals to be repeated by up to 3 compatible repeaters
Network edge (DMZ) host
A LAN PC can be configured as a DMZ host
PPPoE
Dual PPPoE user profiles
ALG support
FTP, PPTP, Layer 2 Tunnelling Protocol (L2TP), IPsec
VPN
Tunnels
• IPsec tunnels with QuickVPN support
• 5 gateway-to-gateway tunnels
Encryption
Triple Data Encryption Standard (3DES)/AES
Authentication
MD5/SHA1
NAT traversal
IPsec
Routing
• Static and Routing Information Protocol (RIP) versions 1 and 2
Environmental
Dimensions
W x H x D
6.6 x 1.65 x 7.62 in.
(170 x 42 x 1 3.5 mm)
Unit weight
0.78 lb (0.355 kg)
Power
12V 1A DC input
Certification
FCC Class B, CE, IC
Operating temperature
32º to 4ºF (0º to 40ºC)
Storage temperature
-4º to 158ºF (-20º to 70ºC)
Operating humidity
% to 85% noncondensing
Storage humidity
5% to 0% noncondensing
Package Contents
• Cisco WRV2 Wireless-G VPN Router
• CD-ROM with user guide and setup wizard
• Network cable
• Power adapter
• Quick install guide
Minimum Requirements
• 802.11b or 802.11g wireless adapter with TCP/IP installed on each PC
• Network adapter with Ethernet network cable
• Web-based configuration: Java-enabled web browser (Internet Explorer, Mozilla, or Firefox)
Product Warranty
3-year limited hardware warranty with return to factory replacement and 0-day limited software warranty
The maximum performance for wireless is derived from IEEE Standard 802.11 specifications. Actual performance can vary, including lower wireless network capacity, data throughput rate, range, and coverage. Performance depends on many factors, conditions, and variables, including distance from the access point, volume of network traffic, building materials and construction, operating system used, mix of wireless products used, interference, and other adverse conditions.
Check the product package and contents for specific features supported. Specifications are subject to change without notice.
Cisco Limited Warranty for Cisco Small Business Series Products
This Cisco Small Business product comes with 3-year limited hardware warranty with return to factory replacement and a 0-day limited software warranty. In addition, Cisco offers software application updates for bug fixes and telephone technical support at no charge for the first 12 months following the date of purchase. To download software updates, go to: http://www.cisco.com/go/smallbiz.
Product warranty terms and other information applicable to Cisco products are available at http://www.cisco.com/go/warranty.
For More Information